Remove a link: EXP II

[jldc]

I have a Wiha 1.5 mm slotted screwdriver. The online tutorial says that the ideal screwdriver is 1.6mm - pretty close. Will that work to remove a link from an Exp II bracelet. I have one on the way from DavidSW. Of course, I could take it to a jeweler, but it would be more convenient to do it myself.

[alpinab7]

It may...?? but to be safe & avoid slips/scratches would get a jeweler to do, probably would be FOC anyhow for just a link (future business & all that)

[Johny]

Originally Posted by jldc

I have a Wiha 1.5 mm slotted screwdriver. The online tutorial says that the ideal screwdriver is 1.6mm - pretty close. Will that work to remove a link from an Exp II bracelet. I have one on the way from DavidSW. Of course, I could take it to a jeweler, but it would be more convenient to do it myself.

would david perhaps loosen one link for you and you can finish the job.

[jldc]

Originally Posted by Johny

would david perhaps loosen one link for you and you can finish the job.

It's already on the way, so that won't work. I keep thinking "how hard can it be?"

[PeterT]

You want to look out for one of these:

http://cgi.ebay.co.uk/Vintage-Rolex-...item27b2bbc8d4

This is not a good one as the screwdriver push pin end is broken.
The screwdriver is a perfect fit.
The end is broader than the 1.6 mm screwdriver and fits the slot perfectly.
You run the risk of putting goudge marks in the end of the screw if your driver is to small.
Also before you attack the screw, warm up the link with a hair dryer as it softens the loctite. Again, less chance of damage.

Peter

[Brenngun]

It's a piece of cake to do this. Apply pressure in a counter clockwise rotational direction until the little post thingy falls out and the link is free. Do this twice then reverse the process once and you done.

[Colnago]

Done it hundreds of times with cheap'ish tiny screwdrivers, on Oyster, President and Jubilee (ladies and gents) bands.....easy peasy....it really isn't a big deal....be gentle to start with and if you're not comfortable with it take it to a jeweller....my guess is you'll wonder why on earth you were worried about doing it

[George Ab]

Go for it! Like other said, it is a piece of cake.

Look over Larry's (Tools) instructions on performing here: http://www.rolexforums.com/showthread.php?t=44158

Larry even address screwdriver size, "It's pretty clear that the 1.2 is too small, but the 1.4 might do in a pinch, however, the 1.6 is perfect and has a more sturdy handle. For this a sturdy, properly fitting tool, is a safeguard against slipping or damage"

So you will be absolutely fine with a 1.5.

[DSJ]

Use Locktite when putting the screw back in!