ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX
|
5 August 2007, 06:05 PM | #1 |
Member
Join Date: Jul 2007
Location: Brisbane Australi
Posts: 17
|
How I clean my Rolex
Just read Roger F's post about cleaning.
I sort of get the impression most of the people that are in this forum have Rolex's that are treated with a lot of TLC Those of you who have read my couple of post [only a member for a few weeks] will know my old Submariner has copped a bit of a pizzling. When it start to look a bit dowdy, use the toothbrush and toothpaste and it comes up sparkling. Sends the tootbrush a funny colour though, but your watch does have clean breath Colin Howkins Australia |
5 August 2007, 06:07 PM | #2 |
Fondly Remembered
Join Date: May 2005
Real Name: JJ
Location: Auckland, NZ
Watch: ALL SOLD!!
Posts: 74,319
|
Welcome to TRF, Colin.
I've found from experience that the toothpaste works wonders on the gold bits!! Cheers - JJ
__________________
Words fail me in expressing my utmost thanks to ALL of you for this wonderful support during my hour of need!! I firmly believe that my time on planet earth is NOT yet up!! I shall fight this to the very end.......and WIN!! |
5 August 2007, 06:17 PM | #3 |
2024 ROLEX DATEJUST41 Pledge Member
Join Date: Feb 2007
Location: Japan
Watch: ing your back.
Posts: 16,179
|
That is what I use on mine. Toothbrush with soap one time and then toothpaste the next. Different brush than what I use to brush my teeth though..
|
5 August 2007, 08:51 PM | #4 |
"TRF" Member
Join Date: Apr 2007
Real Name: Bo
Location: Denmark
Watch: Rolex, of course!
Posts: 22,436
|
I never use a toothbrush on my Rolex.
I only wash it in lukewarm water, using a mild liquid hand soap. Then I dry it off with a clean cotton towel. I also use a piece of kitchen tissue, fold it, and put the folded edge into the small gap between the shoulder guards on my Sub Date. This way I am sure that no water is around the crown when I set the time. I then use the same kitchen tissue to run along the edge between the diving bezel and the crystal, since water tends to be trapped there (not that this would pose any risk to waterproofness, of course, but more due to water later running over the crystal from the gap under the bezel and at the crystal edge). When that (tap) water dries out on the crystal, it is in fact very hard to get rid of the spots afterwards unless you was the watch again.
__________________
With kind regards, Bo LocTite 221: The Taming Of The Screw... |
6 August 2007, 05:57 AM | #5 | |
"TRF" Member
Join Date: Feb 2007
Real Name: Ruben
Location: Orange County
Watch: 16610LV
Posts: 1,317
|
Quote:
I'm with the rest, a soft toothbrush and a spot of natural hand soap, then I dry with an old cotton t-shirt.
__________________
Throw your Rollies in the sky, wave 'em side to side, now keep your hands high. |
|
5 August 2007, 09:08 PM | #6 |
2024 Pledge Member
Join Date: Nov 2006
Real Name: Al
Location: Way Up North
Watch: your P's & Q's
Posts: 10,473
|
Colin, this is what the hard core watch cleaners here use. Note how nicely the Sea Dweller cleaned up.
__________________
Member #1,315 I don't want to get technical, but according to chemistry alcohol IS a solution! |
5 August 2007, 09:10 PM | #7 | |
"TRF" Member
Join Date: Apr 2007
Real Name: Bo
Location: Denmark
Watch: Rolex, of course!
Posts: 22,436
|
Quote:
__________________
With kind regards, Bo LocTite 221: The Taming Of The Screw... |
|
6 August 2007, 12:31 AM | #8 | |
TRF Moderator & 2024 SubLV41 Patron
Join Date: May 2007
Real Name: Larry
Location: Mojave Desert
Watch: GMT's
Posts: 43,514
|
Quote:
I've got all those tools...... Last edited by Tools; 6 August 2007 at 01:44 AM.. |
|
6 August 2007, 12:33 AM | #9 |
2024 Pledge Member
Join Date: Nov 2006
Real Name: Al
Location: Way Up North
Watch: your P's & Q's
Posts: 10,473
|
__________________
Member #1,315 I don't want to get technical, but according to chemistry alcohol IS a solution! |
6 August 2007, 12:40 AM | #10 |
TRF Moderator & 2024 SubLV41 Patron
Join Date: May 2007
Real Name: Larry
Location: Mojave Desert
Watch: GMT's
Posts: 43,514
|
|
5 August 2007, 11:39 PM | #11 |
"TRF" Member
Join Date: Jul 2007
Real Name: Jamie
Location: Georgia
Watch: Stainless Sub Date
Posts: 3,023
|
But without the toothpaste Al can't quite get that minty freshness!
__________________
SUBMARINER OWNERS' CLUB
ESTABLISHED 1953 TRF Member # 5464 |
5 August 2007, 11:43 PM | #12 |
"TRF" Member
Join Date: Jun 2007
Real Name: John
Location: Washington, DC
Posts: 1,150
|
Al, if you and I ever meet I think I'll pass on any offers to let you clean my rollie for me. Thanks but no thanks.
|
5 August 2007, 11:50 PM | #13 |
Member
Join Date: Jun 2007
Real Name: mark
Location: cheshire england
Watch: 16610
Posts: 98
|
Nice 1 al
|
6 August 2007, 01:41 AM | #14 | |
"TRF" Member
Join Date: Jul 2007
Real Name: Ron
Location: Japan
Watch: All of them
Posts: 304
|
Quote:
Toothpaste? You are using gel, I hope?? |
|
6 August 2007, 01:51 AM | #15 |
2024 Pledge Member
Join Date: Nov 2005
Location: Member 202♛
Posts: 1,815
|
I use a Googalies cloth
I use simple soap and water, and sometimes ultrasonic cleaning solution for the bracelet (only), but I use a Googalie cloth to wipe clean (www.googalies.com). These cloths are much better than the Rolex cloth...
-Sheldon
__________________
|
6 August 2007, 04:13 AM | #16 |
Fondly Remembered
Join Date: May 2005
Real Name: JJ
Location: Auckland, NZ
Watch: ALL SOLD!!
Posts: 74,319
|
Al, you're nuts!!
__________________
Words fail me in expressing my utmost thanks to ALL of you for this wonderful support during my hour of need!! I firmly believe that my time on planet earth is NOT yet up!! I shall fight this to the very end.......and WIN!! |
6 August 2007, 04:29 AM | #17 |
Member
Join Date: Jul 2007
Location: Chicago
Watch: GMT-II
Posts: 79
|
I don't usually clean my watch until there's a grotesque amount of shower scum in the bracelet. An hour dip in full-strength Mr. Clean and a rinse makes it good as new.
Not for the squeamish, but it's worked for me for years. |
6 August 2007, 05:53 AM | #18 |
"TRF" Member
Join Date: Apr 2006
Real Name: Paul
Location: Wales, UK
Posts: 14,578
|
I once caught my Googalies in my zip.
It took my mind right off the scratches on my watch.
__________________
..33 |
6 August 2007, 05:54 AM | #19 |
"TRF" Member
Join Date: Jul 2005
Posts: 22,683
|
|
6 August 2007, 10:29 AM | #20 |
Member
Join Date: Dec 2006
Location: U.S.A.
Posts: 407
|
|
6 August 2007, 05:30 PM | #21 |
2024 SubLV41 Pledge Member
Join Date: Nov 2006
Real Name: Eddie
Location: Australia
Watch: A few.
Posts: 37,526
|
Would even a soft tooth brush mark the polished gold on a TT bracelet?
__________________
E |
6 August 2007, 05:33 PM | #22 | |
Fondly Remembered
Join Date: May 2005
Real Name: JJ
Location: Auckland, NZ
Watch: ALL SOLD!!
Posts: 74,319
|
Quote:
Just make sure that there's plenty of soap and running water over the watch while you're using the brush. JJ
__________________
Words fail me in expressing my utmost thanks to ALL of you for this wonderful support during my hour of need!! I firmly believe that my time on planet earth is NOT yet up!! I shall fight this to the very end.......and WIN!! |
|
6 August 2007, 09:12 PM | #23 |
"TRF" Member
Join Date: Jul 2007
Location: Chicagoland
Watch: GMTII and OP!
Posts: 1,272
|
Just did the wife's toothbrush and regular toothpaste routine, and it did a wonderful job! Even with the weekly wearing in the shower never made it look so good, so 4 years of grime is history!
Wish I had a macro lens camera, the beauty marks and perpendicular "bushed" look on the bracelet (i.e. scratches) really show now!
__________________
|
7 August 2007, 01:38 AM | #24 |
TRF Moderator & 2024 SubLV41 Patron
Join Date: May 2007
Real Name: Larry
Location: Mojave Desert
Watch: GMT's
Posts: 43,514
|
Another good reason NOT to wash your watch.....
|
7 August 2007, 03:33 AM | #25 | |
Member
Join Date: Jul 2007
Location: Chicago
Watch: GMT-II
Posts: 79
|
Quote:
|
|
7 August 2007, 08:59 AM | #26 |
Member
Join Date: May 2007
Location: UK
Posts: 114
|
Just soap and water for me. I use a jay cloth on the bracelet.
|
7 August 2007, 11:37 PM | #27 |
"TRF" Member
Join Date: Jul 2007
Location: Chicagoland
Watch: GMTII and OP!
Posts: 1,272
|
I gave her a new one...
__________________
|
7 August 2007, 09:03 AM | #28 |
Member
Join Date: Aug 2007
Location: Canada
Posts: 16
|
I've never heard of taking toothpaste to a watch... I go for the "pay someone to" approach, and take my watches to where they were bought for a professional cleaning. Never watched them clean it, for all I know... they do use toothpaste.
|
7 August 2007, 05:37 PM | #29 |
Fondly Remembered
Join Date: May 2005
Real Name: JJ
Location: Auckland, NZ
Watch: ALL SOLD!!
Posts: 74,319
|
Seriously, toothpaste works very well on GOLD!!
__________________
Words fail me in expressing my utmost thanks to ALL of you for this wonderful support during my hour of need!! I firmly believe that my time on planet earth is NOT yet up!! I shall fight this to the very end.......and WIN!! |
7 August 2007, 08:04 PM | #30 | |
"TRF" Member
Join Date: Apr 2007
Real Name: Bo
Location: Denmark
Watch: Rolex, of course!
Posts: 22,436
|
Quote:
No, the RSC would NOT use toothpaste They would clean the case + band ultrasonically, and the movement parts are cleaned in an electrolysis bath.
__________________
With kind regards, Bo LocTite 221: The Taming Of The Screw... |
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
*Banners
Of The Month*
This space is provided to horological resources.