The Rolex Forums   The Rolex Watch

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

Old 3 October 2008, 09:25 PM   #1
CPTL
"TRF" Member
 
CPTL's Avatar
 
Join Date: Jul 2007
Real Name: Kevin
Location: Texas on my mind
Watch: Sub Date; SS/WG DJ
Posts: 2,445
Bonehead move

I'm not one to baby my watches. I wear my Sub when I'm being active--playing tennis, fishing, exercising, hiking, whatever. I wear my Explorer-II pretty much all day every day, whenever I'm not wearing the Sub. I normally don't pay attention, I just wear the watches and live my life.

Yesterday I wasn't paying attention.

I had been wearing my Sub since playing tennis the previous day, and I swapped out for the Explorer-II last night. I opened the crown and gave it a couple of twists to make sure it was fully wound. Then I hopped into a hot bath to loosen up my back.

After about 30 seconds, I looked down at my Expy, as I tend to do when I'm just sitting around in solitude. And I NOTICED THE CROWN WAS STILL OPEN!!

Of course, I freaked. I've read about other forum members doing the same, but I was worried and pissed at myself for being so careless.

I immediately took off the watch and put it on a dry cloth. It was dry within about ten minutes. I then closed the crown and put the watch back on. I must have gotten out of bed six times over the next two hours looking for fog under the crystal.

Of course, my Expy is fine. The inner gasket kept the water out during the brief encounter with the elements. Glad these things are built so well!!
__________________

16610 Submariner Date; D Serial
16234 DateJust SS with WG Fluted Bezel & Jubillee, White Roman Dial; F Serial
16570 Explorer II White Dial; M Serial

And Hers: 78240 Mid-Size DateJust SS with Domed Bezel & Oyster, White Roman; D Serial
CPTL is offline   Reply With Quote
Old 3 October 2008, 09:27 PM   #2
toph
"TRF" Member
 
toph's Avatar
 
Join Date: Apr 2008
Real Name: ChrisTOPHer
Location: Sydney
Watch: Rolex, Brellum,
Posts: 12,601
wow!! i would have got such a fright,! I bet you nearly slipped and crashed on the floor at the speed you must have jumped out of the bath
__________________


"Where no counsel is the people fall, but in the multitude of counselors there is safety."

Member No.# 11795
toph is offline   Reply With Quote
Old 3 October 2008, 09:28 PM   #3
Quicksilver
"TRF" Member
 
Quicksilver's Avatar
 
Join Date: Jul 2008
Real Name: David
Location: London+Guangzhou
Watch: ing watches
Posts: 2,603
Phew. Glad your watch is ok

Also, this is another testament as to the robustness of Rolex watches.
Quicksilver is offline   Reply With Quote
Old 3 October 2008, 09:55 PM   #4
ROLEX MAN
2024 SubLV41 Pledge Member
 
ROLEX MAN's Avatar
 
Join Date: Jan 2008
Real Name: Martin
Location: Home and Away
Watch: you? "YES PLEASE"!
Posts: 3,719
In three - four days days the watch will self destruct, by turning to mush!
__________________


it's not just about telling the time...

happy rolexing...



I'm just a man with a passion
ROLEX MAN is offline   Reply With Quote
Old 3 October 2008, 10:40 PM   #5
buz-lh
"TRF" Member
 
buz-lh's Avatar
 
Join Date: Dec 2007
Real Name: Buz
Location: Atlanta
Watch: Rolex Tudor Pam
Posts: 5,108
Glad it worked out OK Kevin. They are tough, but I bet your heartrate doubled.
__________________
Buz
The faster you move, the slower time passes, the longer you live. Peter Diamandis

buz-lh is offline   Reply With Quote
Old 4 October 2008, 01:19 AM   #6
kcmo
"TRF" Member
 
Join Date: Jan 2007
Real Name: Karis
Location: USA
Posts: 19,377
Eeeeks, close call Kevin! Glad it turned out OK though! Hope your back is better too!
kcmo is offline   Reply With Quote
Old 4 October 2008, 01:22 AM   #7
Greenring
"TRF" Member
 
Greenring's Avatar
 
Join Date: Aug 2008
Real Name: Stan
Location: Brunswick, Ohio
Watch: All of them
Posts: 967
Darn close one. You dodged the bullet that time and now have a vivid reminder to screw down before going down town.

Last edited by Greenring; 4 October 2008 at 01:23 AM.. Reason: speling iror
Greenring is offline   Reply With Quote
Old 4 October 2008, 01:23 AM   #8
seantk
"TRF" Member
 
seantk's Avatar
 
Join Date: Dec 2007
Real Name: Sean
Location: West Florida
Posts: 2,671
Kevin,

RELIEF!! I know how you feel- I inadvertently left the crown open on my Sea Dweller while I was washing it

Sean
__________________
"Life is frittered away with detail... simplify, simplify!" Henry D. Thoreau
seantk is offline   Reply With Quote
Old 4 October 2008, 01:23 AM   #9
sdwtchlvr
"TRF" Member
 
sdwtchlvr's Avatar
 
Join Date: Sep 2008
Location: SoCal
Watch: Rolex
Posts: 1,308
wow! That is one of my greatest fears!
sdwtchlvr is offline   Reply With Quote
Old 4 October 2008, 01:47 AM   #10
GradyPhilpott
2024 SubLV41 Pledge Member
 
GradyPhilpott's Avatar
 
Join Date: Sep 2008
Location: New Mexico
Watch: Seiko #SRK047
Posts: 34,460
I would recommend having it checked out. I just read a story on another forum about a man who just had his father's old Rolex restored. It looked good from the outside, except for the wear and tear that thirty years will do to a band, watch case, and crystal.

It had stopped running earlier this year for no apparent reason, but when it was opened the devastation to the movement was obvious from a what is presumed to be a similar event. It wasn't exactly mush, but it might as well have been.

This story has a happy ending, but it was an expensive exercise.

http://forums.watchuseek.com/showthread.php?t=154065
GradyPhilpott is offline   Reply With Quote
Old 4 October 2008, 02:02 AM   #11
wristworks
Banned
 
Join Date: Nov 2007
Location: GB
Posts: 220
Glad it's OK. I've never done anything like that with any of my watches but I know exactly how it would feel. I remember once polishing my car and when it came to buffing off the polish I noticed I had picked up the wrong bottle and had actually used back-to-black. (This is meant to make the tyres look black with a wet look for those who don't know the product.) Luckily my car was black but it took quite a few cleans with Autoglym to get it all off. My heart was in my mouth as I'm sure yours was when you did that.
wristworks is offline   Reply With Quote
Old 4 October 2008, 02:04 AM   #12
CKay
"TRF" Member
 
CKay's Avatar
 
Join Date: Jul 2008
Location: Singapore
Posts: 467
No worries Kevin. This is too little a test for the greatness of a Rolex.
__________________

BLACK IS THICKER THAN BLOOD
CKay is offline   Reply With Quote
Old 4 October 2008, 02:13 AM   #13
Alcan
2024 Pledge Member
 
Alcan's Avatar
 
Join Date: Nov 2006
Real Name: Al
Location: Way Up North
Watch: your P's & Q's
Posts: 10,473
The triplock crown sealing system works really well, with the 2 o-rings between the tube and crown stem.


__________________
Member #1,315

I don't want to get technical, but according to chemistry alcohol IS a solution!
Alcan is offline   Reply With Quote
Old 4 October 2008, 02:28 AM   #14
DSJ
"TRF" Member
 
DSJ's Avatar
 
Join Date: Dec 2007
Real Name: David
Location: USA
Watch: your step!
Posts: 7,882
Good save, and proof that even the "lowly Twinlock" is still pretty good!
__________________
Rolex. The Rolex of watches.
16570 Expy2 Noir, 116710 GMT Master II,
2552.80 SMP
DSJ is offline   Reply With Quote
Old 4 October 2008, 02:40 AM   #15
Dalton
TechXpert
 
Dalton's Avatar
 
Join Date: Mar 2008
Real Name: Dal
Location: Seattle
Watch: 168000
Posts: 1,614
lUCKY you. They're tough but forgetting to screwdown the crown leaves it open for a water attack.
Dalton is offline   Reply With Quote
Old 4 October 2008, 02:49 AM   #16
ErikAalto
"TRF" Member
 
ErikAalto's Avatar
 
Join Date: Oct 2007
Real Name: Erik
Location: Clayton, NC
Watch: Datejust
Posts: 322
I had a frustrating scare like this as well. I had read that you could remove your case back with duct tape (can't remember which member had mentioned this), so I grabbed a roll and applied it, but didn't realize that the roll was close to 20 years old. When I tried to remove the tape, the adhesive remained. My watch was covered in adhesive gunk and to top things off, it needed to be sent into service for a new crown/crown tube because it will not screw down. I had to try to get this gunk off as best I could without getting water in the case, so I was ever so carefully trying to hold it at different angles under the faucet and rub it off with my thumb. The adhesive picked up everything that touched it, so it was eventually covered with lint from a towel as well as red lint from my shirt. I was a little flustered over the whole thing.
ErikAalto is offline   Reply With Quote
Old 4 October 2008, 04:10 AM   #17
Art161
"TRF" Member
 
Art161's Avatar
 
Join Date: Jun 2008
Real Name: Art
Location: San Francisco
Watch: Sundial
Posts: 2,266
Quote:
Originally Posted by ErikAalto View Post
I had a frustrating scare like this as well. I had read that you could remove your case back with duct tape (can't remember which member had mentioned this), so I grabbed a roll and applied it, but didn't realize that the roll was close to 20 years old. When I tried to remove the tape, the adhesive remained. My watch was covered in adhesive gunk and to top things off, it needed to be sent into service for a new crown/crown tube because it will not screw down. I had to try to get this gunk off as best I could without getting water in the case, so I was ever so carefully trying to hold it at different angles under the faucet and rub it off with my thumb. The adhesive picked up everything that touched it, so it was eventually covered with lint from a towel as well as red lint from my shirt. I was a little flustered over the whole thing.
There probably won't be a next time for this. On the chance that there is, perhaps some WD-40 sprayed on a microfiber cloth would do the trick. WD-40 is good at removing sticky stuff and microfiber has no lint.
__________________
Rolex SS Oyster Perpetual no date, TT Datejust
Member #13992 HM Power to the Superlative Panda, officially certified! HMPanda eats, shoots and leaves.
Rolexers do it with perpetual movements.
Art161 is offline   Reply With Quote
Old 4 October 2008, 04:15 AM   #18
Art161
"TRF" Member
 
Art161's Avatar
 
Join Date: Jun 2008
Real Name: Art
Location: San Francisco
Watch: Sundial
Posts: 2,266
I'm not all that surprised that there was no damage. Having the crown screwed down is obviously a good idea, but the gaskets protect the watch quite well with the crown not screwed down unless you are at quite a depth in the water. It does remind us that the recommended routine service is necessary so that the gaskets are replaced periodically.
__________________
Rolex SS Oyster Perpetual no date, TT Datejust
Member #13992 HM Power to the Superlative Panda, officially certified! HMPanda eats, shoots and leaves.
Rolexers do it with perpetual movements.
Art161 is offline   Reply With Quote
Old 4 October 2008, 06:56 AM   #19
chicagowatchman
"TRF" Member
 
chicagowatchman's Avatar
 
Join Date: Jul 2007
Location: Chicago IL
Watch: Platinum DDMasterp
Posts: 1,983
Quote:
Originally Posted by toph View Post
wow!! i would have got such a fright,! I bet you nearly slipped and crashed on the floor at the speed you must have jumped out of the bath
__________________
Men's Platinum Day Date Masterpiece
Men's 18k Day Date Crown Collection
Men's Franck Muller 18k Conquistador Cortez
Men's SS Cartier Pasha

MEMBER # 5534 USA
CHICAGO IL
chicagowatchman is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

OCWatches

Wrist Aficionado

My Watch LLC

WatchesOff5th

DavidSW Watches

Takuya Watches


*Banners Of The Month*
This space is provided to horological resources.





Copyright ©2004-2024, The Rolex Forums. All Rights Reserved.

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

Rolex is a registered trademark of ROLEX USA. The Rolex Forums is not affiliated with ROLEX USA in any way.