ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

saxo3 · 10 October 2024, 11:54 PM

Quote:

Originally Posted by cascadez71

After +58 hour measurements where watch failed to read on 3U and 9U, I immediately fully wound watch and started wearing. Put on timeographer 10 minutes later in DU and readings were very wild -300 to -900 s/d, amplitude all over the place.

Very surprising, I have never heard of such behaviour.

Quote:

Originally Posted by cascadez71

Watch was wound fully after 58 hr test but was demonstrating extremely low amplitude and rate even in DU position. Worn during day today was losing 15-20 s/hour. Clearly letting it run down to near 60 hours magnified the issue.

Why should a movement deteriorate drastically after running to about 83% (58/70) of its power reserve?

View Poll Results: Does your 32xx movement seem to be 100% ok?
Yes, no issues	1,059	69.67%
No, amplitude is low (below 200) but timekeeping is still fine	62	4.08%
No, amplitude is low (below 200) and timekeeping is off (>5 s/d)	399	26.25%
Voters: 1520. You may not vote on this poll

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Currently Active Users Viewing This Thread: 8 (1 members and 7 guests)
csaltphoto