ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

mattedialdoc · 2 September 2016, 08:42 PM

I have an insert for my 1675 that is a little misshapen and not snapping in securely. It's not falling out, just not as tight as others...and I'm concerned it could get knocked out. On investigation, It seems to have lost a bit of uniform shape as you look at it from various angles.
Does anyone have a trick to return it to a uniform conical shape? I was thinking to place it over something rounded in a way to reform its shape. Thanks for any tips!!

Formerly known as "SD4Kdoc"

2 September 2016, 08:42 PM	#1
mattedialdoc "TRF" Member Join Date: Feb 2015 Location: Virginia Posts: 1,002	Any tricks fitting misshapen insert onto bezel? I have an insert for my 1675 that is a little misshapen and not snapping in securely. It's not falling out, just not as tight as others...and I'm concerned it could get knocked out. On investigation, It seems to have lost a bit of uniform shape as you look at it from various angles. Does anyone have a trick to return it to a uniform conical shape? I was thinking to place it over something rounded in a way to reform its shape. Thanks for any tips!! Formerly known as "SD4Kdoc"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)