Royal Oak 41mm [REF: 15500ST] Measurements Question - 3D Print

[aparezco]

Hello Forum,

Since I have not been able to find any 41mm Royal Oak [REF: 15500ST.OO.1220ST.01] to try on my wrist for size, I was wondering if any of you could please provide me with measurements of the watch taken with a caliper.

I want to 3D print the watch to see if it fits me right, I found a model of the watch to print but I think the sizing is not right on it (I think the case on the model I found is too long).

I need these measurements:
A) Lug tip to lug tip
B) Crystal
C) Case edge to case edge

Here is a picture showing in detail the measurements I'm trying to get:


Thank you for any help!