The Rolex Forums   The Rolex Watch

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX


Go Back   Rolex Forums - Rolex Forum > Rolex & Tudor Watch Topics > Rolex General Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 16 December 2021, 01:19 AM   #1
roadrunner117
"TRF" Member
 
Join Date: Jun 2015
Location: USA
Posts: 85
Advice on removing link screws from full gold bracelet

I'm thinking about pulling the trigger on a full white-gold piece, and one of the things I noticed was that the link screws do not go all the way to the other end of the link. In other words, the female end is closed from the outside on the other side of the link. Normally, on stainless models, I would heat the female end with a blow dryer in order to loosen the loctite, since you can easily see the other end of the screw. On full gold models, would you still recommend using a blow dryer on the closed female end of the link, even though the end of the screw can't be seen? Would this even be effective at loosening the loctite at all?
roadrunner117 is offline   Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Wrist Aficionado

My Watch LLC

WatchesOff5th

DavidSW Watches

Takuya Watches

OCWatches


*Banners Of The Month*
This space is provided to horological resources.





Copyright ©2004-2024, The Rolex Forums. All Rights Reserved.

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

Rolex is a registered trademark of ROLEX USA. The Rolex Forums is not affiliated with ROLEX USA in any way.