ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

ChicagoBigHouse · 11 October 2010, 08:41 AM

I was hoping for a little help. I was trying to change my jubilee bracelet on my D series pepsi GMT II to an oyster bracelet. I have the Bergeon 6825-with the fork tip ends to be compatible with rolex. However, the fork tip ends are still too wide to fit in the slot where the spring bar is located to remove my jubilee bracelet.

Anyone run into the same issue, and/or have any advice?

Thanks a lot.

Justin

11 October 2010, 08:41 AM	#1
ChicagoBigHouse "TRF" Member Join Date: Nov 2009 Real Name: Justin Location: Columbus Watch: No rolex currently Posts: 132	Does anyone use the Bergeon 6825 springbar tool? I was hoping for a little help. I was trying to change my jubilee bracelet on my D series pepsi GMT II to an oyster bracelet. I have the Bergeon 6825-with the fork tip ends to be compatible with rolex. However, the fork tip ends are still too wide to fit in the slot where the spring bar is located to remove my jubilee bracelet. Anyone run into the same issue, and/or have any advice? Thanks a lot. Justin

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)