Pam stopped winding on winder

[HyperM3]

Im totally perplexed about this situation. I have a wolf quattro winder with most of my consistantly worn watches in it. Whenever my Pam is put on it, it stops winding and goes dead. Even when I can see the rotator is active and spinning the watch, it still doesnt wind.

When I wear the watch after a few hours I can see it goes to full(its a 90 with power reserve). When I let the watch sit for a day or so and then wear it again it winds up again and hasnt lost any time(or gained any).

I never use the same winding cuff in a row as I swap from watch to watch and put the prior watch on the cuff of the one Im taking out. This takes away any response that its a specific winder of the four that isnt working.

I got the watch in 2007 and didnt think it would have worn down that fast in terms of needing a service.

Any ideas?