ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

jatco · 29 March 2015, 11:51 AM

?? . wish I knew...
..But Im sure somebody knows...!!!

nintendo · 29 March 2015, 10:12 PM

Yes you can make micro adjustment on the clasp. Just as you would on an older rolex clasp. The bracelet is just attached to the clasp using a springbar. You can just use a pointed tool to compress one side first.

SemperFi · 29 March 2015, 10:35 PM

Quote:

Originally Posted by nintendo

Yes you can make micro adjustment on the clasp. Just as you would on an older rolex clasp. The bracelet is just attached to the clasp using a springbar. You can just use a pointed tool to compress one side first.

That's great. Thank you. I could use that tiny bit of an adjustment for a more comfortable fit.

mjh315 · 30 March 2015, 01:25 AM

Does anyone know if and where one can purchase the Tudor distressed leather strap for the black bay! I purchased a grey market stainless steel bracelet model but I want that strap!

SemperFi · 30 March 2015, 01:47 AM

Quote:

Originally Posted by mjh315

Does anyone know if and where one can purchase the Tudor distressed leather strap for the black bay! I purchased a grey market stainless steel bracelet model but I want that strap!

Check the classifieds on the forum first. An OEM strap is pricey.

For aftermarket try Holben's.
http://www.holbensfinewatchbands.com...-aviator-sand/

Also k-straps.com

SemperFi · 30 March 2015, 09:22 AM

Quote:

Originally Posted by nintendo

Yes you can make micro adjustment on the clasp. Just as you would on an older rolex clasp. The bracelet is just attached to the clasp using a springbar. You can just use a pointed tool to compress one side first.

I just wanted to thank you again for the tip. I used a straight pin to depress the spring bar and had it adjusted to my liking in about 10 seconds.

ronin_ph · 30 March 2015, 10:03 AM

Quote:

Originally Posted by SemperFi

I just wanted to thank you again for the tip. I used a straight pin to depress the spring bar and had it adjusted to my liking in about 10 seconds.

SemperFi Do or Die!

Sent from my iPhone using Tapatalk

Musicman79 · 30 March 2015, 11:47 PM

Does anyone know about refreshing BB with in-house movement? I'm going to buy BB so maybe I should wait.

mikelcch · 31 March 2015, 12:29 AM

Quote:

Originally Posted by Musicman79

Does anyone know about refreshing BB with in-house movement? I'm going to buy BB so maybe I should wait.

It could happen and probably will. Perhaps they'll use the same movement in the Plato's or North Flag but that means there will be a date ala Tudor Submariner. But then again it'll probably be more expensive as well.

This would make more sense than just issuing a new reference with just a new movement and adding a few liners on the dial (which makes it look more cluttered!)

I could be wrong. But if you're gonna wait and IF you can wait, well then you can look forward to the next Basel announcement which is almost a year away. If it happens then you waiting game pays off. If not...well then you'll probably be waiting again... I'd say just do it! Good luck!

nintendo · 31 March 2015, 08:14 PM

Quote:

Originally Posted by SemperFi

I just wanted to thank you again for the tip. I used a straight pin to depress the spring bar and had it adjusted to my liking in about 10 seconds.

No problem at all. Glad you have adjusted to your liking. The watch head is rather heavy so it is good to adjust the bracelet to reduce movement. ;)

Old Expat Beast · 31 March 2015, 09:42 PM

Does the BB have a flat caseback, like the THC?

Nsx_23 · 31 March 2015, 10:04 PM

Yep, flat caseback.

Old Expat Beast · 31 March 2015, 10:14 PM

That's good, thanks.

Nsx_23 · 31 March 2015, 10:38 PM

New addition to the ranger?

SemperFi · 31 March 2015, 11:35 PM

I've had my Black Bay for five days now and it's running 2+ seconds per day which I think is just fantastic. Can't tell you how pleased I am with this watch and it's accuracy so far.

Old Expat Beast · 1 April 2015, 12:09 AM

Quote:

Originally Posted by Nsx_23

New addition to the ranger?

Maybe, if the euro is still down when I get back to Italy.

SemperFi · 1 April 2015, 12:10 AM

Quote:

Originally Posted by Old Expat Beast

Maybe, if the euro is still down when I get back to Italy.

Go for it Adam. It's a great watch.

Daddy_Terj · 2 April 2015, 03:31 AM

I have two Black Bays... Red + Blue both on leather. Would anyone know if it's possible to buy SS bracelets to switch?

els4 · 2 April 2015, 05:31 AM

Angelo, I've had my BBB since the U.S. Release last summer, and it was running at approx +1.5 sec/day when it was new, and has since then settled in to 0 to +0.5 sec/day (checked according to USNO time. Fantastic accuracy. The BB certainly is a lot of bang for the buck. I couldn't be happier with mine. I hope you enjoy yours.

SemperFi · 2 April 2015, 05:36 AM

Quote:

Originally Posted by els4

Angelo, I've had my BBB since the U.S. Release last summer, and it was running at approx +1.5 sec/day when it was new, and has since then settled in to 0 to +0.5 sec/day (checked according to USNO time. Fantastic accuracy. The BB certainly is a lot of bang for the buck. I couldn't be happier with mine. I hope you enjoy yours.

I'm loving this watch Edgars and really didn't expect this type of accuracy out of the box. In fact I'm sitting in the car now (parked) and just staring at it in the sunlight.
Glad you're having great results with yours too!

SemperFi · 3 April 2015, 03:43 AM

Got my Bonetto Cinturini rubber strap in the mail yesterday and today received the Bergeon 6767F spring bar tool. So I jumped right into it and made the switch.

DKRanger22 · 3 April 2015, 04:06 AM

Looks great, Angelo!

SemperFi · 3 April 2015, 04:15 AM

Quote:

Originally Posted by DKRanger22

Looks great, Angelo!

Thanks Andrew. Hope you're enjoying your DJII as much as I'm loving this one.
Oh, and, I know you asked me not to post too many pics of the BB so I limited it to only two.

SemperFi · 3 April 2015, 11:05 AM

By the way, the Bergeon spring bar tool works great. It took me about 20 minutes to get the bracelet off but it was the first time I ever did it and it was no fault of the tool. I was just being extra careful not to slip up and scratch the lugs or caseback.

rlee · 5 April 2015, 08:31 AM

I love Bonetto Cinturini straps. The vanilla scented rubber is a great conversation starter.

dubbab20 · 5 April 2015, 08:54 AM

Joining the party, first post!

SemperFi · 5 April 2015, 09:22 AM

Quote:

Originally Posted by rlee

I love Bonetto Cinturini straps. The vanilla scented rubber is a great conversation starter.

It does smell nice. I can smell it as I'm typing this reply.

I don't know if it'll wear a little warm during the summer months so I may spring for an Isofrane too.

sickened1 · 5 April 2015, 10:15 AM

Just got this from Takuya.

SemperFi · 5 April 2015, 10:20 AM

Nice going Ed. It's a great watch and I think you're going to love it. Congrats to you!

sickened1 · 5 April 2015, 11:13 AM

Quote:

Originally Posted by SemperFi

Nice going Ed. It's a great watch and I think you're going to love it. Congrats to you!

Thanks Angelo. I'm liking it a lot already. It feels really nice on the wrist and also feels even heavier than some of the subs I own.

29 March 2015, 11:51 AM	#361
jatco 2024 SubLV41 Pledge Member Join Date: Feb 2010 Real Name: Thomas Location: YVR Watch: 116233/79190 Posts: 50,588	?? . wish I knew... ..But Im sure somebody knows...!!! __________________ . ..- ' A Crown for every achievement '

29 March 2015, 10:12 PM	#362
nintendo "TRF" Member Join Date: Mar 2014 Location: Singapore Posts: 333	Yes you can make micro adjustment on the clasp. Just as you would on an older rolex clasp. The bracelet is just attached to the clasp using a springbar. You can just use a pointed tool to compress one side first.

30 March 2015, 01:25 AM	#364
mjh315 "TRF" Member Join Date: Nov 2014 Location: USA Posts: 75	Does anyone know if and where one can purchase the Tudor distressed leather strap for the black bay! I purchased a grey market stainless steel bracelet model but I want that strap!

30 March 2015, 11:47 PM	#368
Musicman79 "TRF" Member Join Date: Dec 2013 Location: Warsaw, Poland Posts: 1	Does anyone know about refreshing BB with in-house movement? I'm going to buy BB so maybe I should wait.

31 March 2015, 09:42 PM	#371
Old Expat Beast TRF Moderator & 2024 SubLV41 Patron Join Date: Jul 2013 Real Name: Adam Location: Far East Watch: Golden Tuna Posts: 28,829	Does the BB have a flat caseback, like the THC?

31 March 2015, 10:04 PM	#372
Nsx_23 "TRF" Member Join Date: Jul 2014 Location: Earth Posts: 607	Yep, flat caseback.

31 March 2015, 10:14 PM	#373
Old Expat Beast TRF Moderator & 2024 SubLV41 Patron Join Date: Jul 2013 Real Name: Adam Location: Far East Watch: Golden Tuna Posts: 28,829	That's good, thanks.

31 March 2015, 10:38 PM	#374
Nsx_23 "TRF" Member Join Date: Jul 2014 Location: Earth Posts: 607	New addition to the ranger?

31 March 2015, 11:35 PM	#375
SemperFi "TRF" Member Join Date: Sep 2014 Real Name: Angelo Location: Brooklyn, NY Watch: Rolex Submariner Posts: 42,164	I've had my Black Bay for five days now and it's running 2+ seconds per day which I think is just fantastic. Can't tell you how pleased I am with this watch and it's accuracy so far.

2 April 2015, 03:31 AM	#378
Daddy_Terj "TRF" Member Join Date: Jan 2015 Real Name: Pippin Location: West London, UK Watch: Yachmaster Posts: 87	I have two Black Bays... Red + Blue both on leather. Would anyone know if it's possible to buy SS bracelets to switch?

2 April 2015, 05:31 AM	#379
els4 "TRF" Member Join Date: Jun 2009 Real Name: Edgars Location: Southeastern PA Watch: Wimbledon DJ Posts: 201	Angelo, I've had my BBB since the U.S. Release last summer, and it was running at approx +1.5 sec/day when it was new, and has since then settled in to 0 to +0.5 sec/day (checked according to USNO time. Fantastic accuracy. The BB certainly is a lot of bang for the buck. I couldn't be happier with mine. I hope you enjoy yours.

3 April 2015, 03:43 AM	#381
SemperFi "TRF" Member Join Date: Sep 2014 Real Name: Angelo Location: Brooklyn, NY Watch: Rolex Submariner Posts: 42,164	Got my Bonetto Cinturini rubber strap in the mail yesterday and today received the Bergeon 6767F spring bar tool. So I jumped right into it and made the switch.

3 April 2015, 04:06 AM	#382
DKRanger22 "TRF" Member Join Date: Dec 2012 Real Name: Andrew Location: Cleveland Posts: 557	Looks great, Angelo!

3 April 2015, 11:05 AM	#384
SemperFi "TRF" Member Join Date: Sep 2014 Real Name: Angelo Location: Brooklyn, NY Watch: Rolex Submariner Posts: 42,164	By the way, the Bergeon spring bar tool works great. It took me about 20 minutes to get the bracelet off but it was the first time I ever did it and it was no fault of the tool. I was just being extra careful not to slip up and scratch the lugs or caseback.

5 April 2015, 08:31 AM	#385
rlee "TRF" Member Join Date: May 2013 Location: Canada Watch: 25500TN Posts: 64	I love Bonetto Cinturini straps. The vanilla scented rubber is a great conversation starter.

5 April 2015, 08:54 AM	#386
dubbab20 "TRF" Member Join Date: May 2014 Location: Cville Posts: 2	Joining the party, first post!

5 April 2015, 10:15 AM	#388
sickened1 2024 SubLV41 Pledge Member Join Date: Aug 2014 Real Name: Ed Location: SoCal Watch: ugiveiswatchuget Posts: 9,054	Just got this from Takuya.

5 April 2015, 10:20 AM	#389
SemperFi "TRF" Member Join Date: Sep 2014 Real Name: Angelo Location: Brooklyn, NY Watch: Rolex Submariner Posts: 42,164	Nice going Ed. It's a great watch and I think you're going to love it. Congrats to you!

Currently Active Users Viewing This Thread: 13 (0 members and 13 guests)