The Rolex Forums   The Rolex Watch

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX


Go Back   Rolex Forums - Rolex Forum > Rolex & Tudor Watch Topics > Rolex General Discussion

Reply
 
Thread Tools Display Modes
Old 17 April 2019, 01:25 AM   #1
Tools
TRF Moderator & 2024 SubLV41 Patron
 
Tools's Avatar
 
Join Date: May 2007
Real Name: Larry
Location: Mojave Desert
Watch: GMT's
Posts: 43,514
Quote:
Originally Posted by Adam Brian View Post
Hey guys,

Bought my Oyster Perpetual a few months ago. The power reserve was fine when I bought it (I think, I was wearing it so much that I didn't really give it a chance to use the reserve haha). Anyways, it only runs for about 36-38 hours now. This would normally be fine for me but I have school in the morning and it is a pain manually rewinding it when I have to be at school in 10 minutes since the last thing I do is put on my watch.. . .
So your real problem is poor time management.

Your watch is likely perfectly fine. You are simply not active enough to fully top off your watch on a daily basis, hence, you only see what you have put into it. It is not magic, it is your daily activity that winds your watch.

In any event, I don't see your problem. Give your watch a few winds when you take it off at night and you won't have to worry about it when you are rushing in the morning.
__________________
(Chill ... It's just a watch Forum.....)
NAWCC Member
Tools is offline   Reply With Quote
Old 17 April 2019, 02:15 AM   #2
Hub6152
Banned
 
Join Date: Apr 2018
Location: Hong Kong
Posts: 893
Four independent watchmakers were posed the question about winders by one of the online watch magazines not so long ago. Their opinion was spilt 50/50 and the verdict was inconclusive. It’s personal choice and, as long as proper maintenance is observed, a good quality winder is a perfectly acceptable device to use. It’s really that simple.
Hub6152 is offline   Reply With Quote
Old 19 April 2019, 07:31 PM   #3
watchmaker
TechXpert
 
watchmaker's Avatar
 
Join Date: Feb 2009
Real Name: Scott
Location: London
Posts: 2,242
Quote:
Originally Posted by Hub6152 View Post
Four independent watchmakers were posed the question about winders by one of the online watch magazines not so long ago. Their opinion was spilt 50/50 and the verdict was inconclusive. It’s personal choice and, as long as proper maintenance is observed, a good quality winder is a perfectly acceptable device to use. It’s really that simple.
This is spot on.

A watch winder simulates continuous wear which is accounted for in the manufacturer’s advised service intervals.

There will be examples of early failure and examples of watches that just keep on truckin for years after they should have died. But for the majority of watches there will be no ill effects from use of a winder or from leaving it to stop when you don’t wear it.
watchmaker is offline   Reply With Quote
Old 17 April 2019, 02:26 AM   #4
joe100
2024 SubLV41 Pledge Member
 
joe100's Avatar
 
Join Date: Nov 2007
Real Name: Joe
Location: New Mexico
Watch: Explorer
Posts: 12,840
In motion = wear
Not in motion = no wear

They don’t use all of those different oils for nothing.

If I’m not wearing it, I don’t want it to be running.
__________________
It's Espresso, not Expresso. Coffee is not a train in Italy.
-TRF Member 6982-
joe100 is offline   Reply With Quote
Old 17 April 2019, 02:57 AM   #5
Sublovin
2024 Pledge Member
 
Sublovin's Avatar
 
Join Date: Sep 2012
Location: USA
Watch: Lots
Posts: 4,595
Quote:
Originally Posted by joe100 View Post
In motion = wear
Not in motion = no wear

They don’t use all of those different oils for nothing.

If I’m not wearing it, I don’t want it to be running.
Right
Just because a watch is designed to run, doesn’t mean one should force the issue when not needed.
__________________
DSSD is the king of all Rolex
Sublovin is offline   Reply With Quote
Old 17 April 2019, 02:57 AM   #6
Colin G
"TRF" Member
 
Colin G's Avatar
 
Join Date: Feb 2018
Location: Canada
Watch: 216570, 214270
Posts: 683
My EXPII has never been at a 48 hrs reserve and it is about 1 year old.

I think 48 hrs is a stretch. I bet I'm around 36 hrs also and I wear mine daily but the odd time I don't for a day or two and always have to set the time, even after a full wind.

My wife's OP26 is about the same. Not near 48hrs and her watch is not even a year old as well.
Colin G is offline   Reply With Quote
Old 17 April 2019, 03:19 AM   #7
Luap1976
"TRF" Member
 
Join Date: Sep 2015
Location: London Uk
Watch: 116610lnBBetaBBhar
Posts: 1,005
Quote:
Originally Posted by Colin G View Post
My EXPII has never been at a 48 hrs reserve and it is about 1 year old.

I think 48 hrs is a stretch. I bet I'm around 36 hrs also and I wear mine daily but the odd time I don't for a day or two and always have to set the time, even after a full wind.

My wife's OP26 is about the same. Not near 48hrs and her watch is not even a year old as well.
If your winding the watch 40 to 50 times cw and putting it down to test and you not getting past 48 hours or super close there is an issue imo
Luap1976 is offline   Reply With Quote
Old 17 April 2019, 03:32 AM   #8
Colin G
"TRF" Member
 
Colin G's Avatar
 
Join Date: Feb 2018
Location: Canada
Watch: 216570, 214270
Posts: 683
Quote:
Originally Posted by Luap1976 View Post
If your winding the watch 40 to 50 times cw and putting it down to test and you not getting past 48 hours or super close there is an issue imo
I am going to do an actual timed test tonight so no more speculation. In the recent past I have set it down after a full wind and not touched it for around 1 1/2 to 2 days and it is always stopped.

I'll give it a full wind and check back in 48 hrs and see. I'll even check in at 40 hrs also.
Colin G is offline   Reply With Quote
Old 19 April 2019, 12:43 PM   #9
Colin G
"TRF" Member
 
Colin G's Avatar
 
Join Date: Feb 2018
Location: Canada
Watch: 216570, 214270
Posts: 683
Quote:
Originally Posted by Colin G View Post
I am going to do an actual timed test tonight so no more speculation. In the recent past I have set it down after a full wind and not touched it for around 1 1/2 to 2 days and it is always stopped.

I'll give it a full wind and check back in 48 hrs and see. I'll even check in at 40 hrs also.
I checked in with my reserve test early. A whopping 34 hours is all I could get so not even close to 48 hours reserve.

I gave the watch a full wind at 5:30 am yesterday on the 17th and let it sit undisturbed until I checked in today and it stopped today at 3:30 pm. I should be getting more reserve than that.
Colin G is offline   Reply With Quote
Old 17 April 2019, 03:44 AM   #10
jcross
"TRF" Member
 
Join Date: Apr 2019
Real Name: Jay
Location: Michigan
Watch: Rolex Submariner
Posts: 62
If winders caused extra damage to a watch, nobody would buy them and no AD would recommend them. My AD said its good to keep it running so the lubricants don't dry out. Letting it run down and rewinding I'm sure it also just fine as long as your watch doesn't sit for months on end without running. Everyone will do what makes them feel good and at the end of the day if I can afford a Rolex I can afford the service, so who cares!
jcross is offline   Reply With Quote
Old 17 April 2019, 05:30 AM   #11
Sublovin
2024 Pledge Member
 
Sublovin's Avatar
 
Join Date: Sep 2012
Location: USA
Watch: Lots
Posts: 4,595
Quote:
Originally Posted by jcross View Post
If winders caused extra damage to a watch, nobody would buy them and no AD would recommend them. My AD said its good to keep it running so the lubricants don't dry out. Letting it run down and rewinding I'm sure it also just fine as long as your watch doesn't sit for months on end without running. Everyone will do what makes them feel good and at the end of the day if I can afford a Rolex I can afford the service, so who cares!
I don’t think anybody said EXTRA
Your AD is about 30 years behind on lubricants
__________________
DSSD is the king of all Rolex
Sublovin is offline   Reply With Quote
Old 17 April 2019, 05:11 AM   #12
Adam Brian
"TRF" Member
 
Join Date: Oct 2018
Real Name: Adam Brian
Location: Bowling Green, OH
Posts: 108
Thanks for all of the responses haha. I don't know why I didn't realise that it wouldn't have been fully winded when I took it off after wearing it . I will start winding it up after I take it off at night and also I will do a test and see how much the power reserve is. The reason I don't wear it all the time is because I also wear my Omega Seamaster often too. Also, thanks for giving me all of this new information about watch winders!
Adam Brian is offline   Reply With Quote
Old 19 April 2019, 03:01 PM   #13
Likestheshiny
"TRF" Member
 
Join Date: Apr 2017
Location: _
Posts: 1,877
Quote:
Just because a watch is designed to run, doesn’t mean one should force the issue when not needed.
This can be true at the same time as an analogy to an internal combustion engine can be silly.

If you have a reasonable point to make, there's no need to exaggerate to make it. No analogy is perfect, but if that was the best you could find then it suggests a weakness in your argument in the first place.
Likestheshiny is offline   Reply With Quote
Old 19 April 2019, 03:26 PM   #14
Hub6152
Banned
 
Join Date: Apr 2018
Location: Hong Kong
Posts: 893
And still no one ever produces any actual evidence that winders cause extra wear beyond that of normal use age. The anti winder brigade should stop dissing on those that choose to use them.
Hub6152 is offline   Reply With Quote
Old 19 April 2019, 04:51 PM   #15
InitialAndPitch
Banned
 
Join Date: Mar 2019
Location: Australia
Watch: GMT-II BLRO PEPSI
Posts: 597
I was in a dealers store recently and asked about winders. He said that if watches needed winders they would come with one. Then I noticed behind him a wall covered in every brand of winder you can imagine. I’ve never seen hard evidence on yes or no to winders only divided opinion.

I have a friend who is renovating and is having one or two 32 place winders built into his walk in robe. Insanity.
InitialAndPitch is offline   Reply With Quote
Old 19 April 2019, 09:26 PM   #16
zengineer
"TRF" Member
 
zengineer's Avatar
 
Join Date: Jul 2016
Location: Michigan
Posts: 4,588
I have a half dozen watches I rotate, most are autos and most get stored on winders, especially those with day/date (not a Rolex Day Date).

Somehow, even though I have an actual job, I am able to allow time to set and/or wind my watch in the morning. I know the OP currently finds it a bit daunting and must be in awe of my exceptional skills, but I say to him... set this as your goal, apply yourself and never ever quit. Or just set your alarm 2 minutes early...that will work too.
zengineer is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

WatchesOff5th

DavidSW Watches

Takuya Watches

OCWatches

Asset Appeal

Wrist Aficionado

My Watch LLC


*Banners Of The Month*
This space is provided to horological resources.





Copyright ©2004-2024, The Rolex Forums. All Rights Reserved.

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

Rolex is a registered trademark of ROLEX USA. The Rolex Forums is not affiliated with ROLEX USA in any way.