Rectangular chronograph buttons

[Passionata]

please educate me , i understand how screw in type buttons are fitted , , basically a tube screwed into the case which holds the stem with the pusher , but how the rectangular ones are fitted -the ones where the button slides INTO the case , here s a pic from patek obviously w/o the answer to my question



is there a "hole" in the case which holds the tube and let the pusher sliding in ?

thanks

[SearChart]

There is a cutout in the shape of the pusher. Then a hole with tube for the actual pusher mechanism that is in touch with the movement.

The round pusher just screws on to the underside of the square pusher. Basically works the same as a regular pump-pusher, just with a different button and case cutout.

[unreformed66]

Originally Posted by SearChart

There is a cutout in the shape of the pusher. Then a hole with tube for the actual pusher mechanism that is in touch with the movement.

The round pusher just screws on to the underside of the square pusher. Basically works the same as a regular pump-pusher, just with a different button and case cutout.

Exactly. Until you get into vintage chronographs where the pusher is not part of the case but just passes through the hole in the side of the case. Those have a slot cut out of the pusher stem and are held to the movement by the operating levers much in the way a regular stem is held in with the detent. You unscrew the operating lever, put the pusher in place, and screw the operating lever screw back down with the lever in the slot in the pusher stem. And yes, they can be fiddly to work with sometimes.

[SearChart]

Actually that picture answers the question. You only need to imagine a rectangular cutout with a round hole in the middle. It fits right in.

[Passionata]

thanks,
found a good pic it shows the details better it shows how the tube sits in the hole (actually that was OQ) , and other thing Geneva Seal doesn t allow the use of wire springs (I know PP has its own seal but still) am I right that these buttons on the pic are operated without those ?how they return into their original position with a leaf spring ?also i don t see the "rod" which is screwed underside to the button like on the regular chrono pusher , is it a safe assumptio that these pusher are glued press fitted into the case and a "tube" inside moves back and forth?sorry for too many questions

Originally Posted by SearChart

Actually that picture answers the question. You only need to imagine a rectangular cutout with a round hole in the middle. It fits right in.

[SearChart]

I wish I could take a 5980 from the stock to show you, but sadly I cannot be of help.