Proper Bergeon Tools for Bracelet/RubberB Replacement?

[Kappy94]

I bought the 7825 and 6767-S tool but I think the 6767-F tool would be better for the batman Oyster bracelet replacement. I want to basically figure out the correct workflow to remove the RubberB strap and then replace the Oyster bracelet and vice versa. I'm thinking that it makes sense to remove and replace the metal bracelet with the 7825 so that both spring bars can be depressed at the same time and use the 6767 to remove the RubberB band one side at a time to pop the spring bars out. Does that make sense? Is there another tool I should be using? I also bought electrical tape to protect the lugs on each side. But I'd love tips on best practices and other tools I should buy instead, etc

[destr0y26]

I'm not sure that a repeatable workflow really matters, as long as you're careful during the process.

For example: I routinely switch out the oyster bracelet and glidelock clasp on my 114060 submariner in favor of a white Everest strap during the summer months. My typical workflow is to remove the bracelet entirely from the head; followed by using a jewelers screwdriver to remove the 6 o'clock portion of the oyster from the glidelock clasp and replacing with the 6 o'clock portion of the Everest; removing the 12 o'clock portion of the oyster from the glidelock clasp and replacing with the 12 o'clock portion of the Everest; and finally finishing with the re-attachment of the bracelet to the watch head.

As far as which spring bar tool I use, it really depends on which one is closer to me at that given time. Sometimes I use my Bergeron 6767-F and sometimes I use the Omega spring bar tool that came with my Speedy Pro. As long as I'm careful to not gouge the underside of the lugs or end links, I find that they both get the job done equally as well.

If you're concerned with scratching the side of the links when removing the screws, place a small strip of scotch tape over the side of the end link prior to removing the screw(s). This will provide a thin barrier, in case you slip, that you can still insert your screwdriver through.

(The majority is only relevant if you're continuing to use the Rolex clasp with the after-market strap. If you're only using a strap with a tang style buckle, then disregard my bit about removing/reinstalling the glidelock).

[fskywalker]

Think either device can be used with either watch / bracelet


Sent from my iPhone using Tapatalk Pro

[Undefeatable]

What you said is exactly what I do. For the bracelet (removal and installation), I use spring bar pliers (cheap ones off Amazon). For my Rubber B, I install and remove it using a standard spring bar tool.


Sent from my iPhone using Tapatalk

[RJRJRJ]

The S or F doesn't matter really as those are for bracelets. You want the flat tip for straps.
https://www.esslinger.com/bergeon-61...at-forked-end/